G&L 84” Vertical Turning Center with Live Milling

 

Before

Before
Actual machine

After

After
Not actual machine

 

Giddings and Lewis 84” Vertical Turning Center

KRC Machine Tool Services is pleased to offer the following Certified Used Giddings and
Lewis 84” Vertical Turning Center with Live Milling for your consideration.

G&L 84” Vertical Turning Center Specifications

 

Model Giddings & Lewis 84” VBM with Live Milling

Fanuc or Siemens CNC Retrofit 2018 (see scope of work)

CNC Control Fanuc 0i-TD

Table Diameter 84”

Table Swing 96″

Max Height Under Cross Rail 96″

Vertical Ram Stroke 50”

Vertical Ram Taper #60 ANSI

Vertical Ram Cross Section 10.5” x 10.5”

Table Speed (2 ranges) 2 – 240 RPM

Table Load 250,000 LBS

Spindle Drive 100 HP

Rapid Traverse Rate 150 IPM

Feed Rate 0.1-150 IPM

45 Tool ATC Yes

Chip-Conveyor Yes

High Volume Flood Coolant Yes

Coolant Thru Center of Ram Yes

Telescopic Covers (cross rail) Yes

Machine Options

 

Side Head Ram Travel 32”

Side Head Ram Tool Taper #50 ANSI

24 Tool ATC Yes

Paint Machine Customer Specified

Equipped With:
  • Fanuc or Siemens CNC Retrofit
  • New Operators Station
  • 45 Position Automatic Tool Changer
  • Power Draw Bar on Ram
  • 84” Plain Table w/ 16 Radial Slots
  • 360,000 Degree Table Positioning
  • Ballscrews & Independent Servos
  • Way Covers
  • Chip Conveyor
  • Hardened & Ground Ways
  • 25 HP Milling Spindle
  • 100 HP Main Motor 460/3/60 Cycle

 


F.O.B. Kentucky Rebuild Corp., Independence, KY

Delivery TBD

Warranty 1 year electrical and mechanical

*All machine specifications are subject to verification

Mechanical Features of This Proposal:

Mechanical Systems:

  • Complete mechanical assembly & evaluation of the machine
  • Clean & inspect ball screws and rail lifting screws
  • Clean & Inspect table transmission & bearings
  • Rebuild lubrication system
  • Rebuild hydraulics system
  • Inspect all wear material
  • Install new way wipers as needed
  • Rebuild way covers
  • Rebuild chip conveyor
  • Full one-year warranty, parts and labor

Electrical Features of This Proposal:

  • All new electrical & electronics including a Fanuc 0i-TD CNC
  • New Fanuc Alpha AC servomotors and drives on all servo controlled axes
  • Rebuild the existing 100HP Main Spindle Motor
  • New pre-wired back NEMA 12 magnetic panel enclosure
  • New operators panel in a new pedestal mounted enclosure
  • Complete rewiring of the machine
  • Complete documentation package
  • Full one year warranty, parts, and labor. Fanuc parts warranty – two years

*All machine specifications are subject to verification